Macrom 43.07 Manuel d'utilisateur télécharger pdf (Page 7)

A B

LEFT LEFT RIGHTRIGHT

MONO MONO

CONNECTIONS

1. Battery lead: Connect the BATT-terminal

11 directly to the car‘s battery with a yellow lead of

adequate section.

Do not connect this lead to circuits existing within the electric system of the car. In order to avoid

damage to the car it is imperative that this lead be fitted with a fuse (not provided) as near as

possible to the car‘s battery. This connection is the to be carried out last.

2. Remote switch-on lead: Connect the (REMOTE) switch-on lead or the control lead of the

power antenna coming from the head unit (blue) to the REMOTE terminal

13 of the amplifier.

NOTE: In case this lead is not connected, the amplifier will not be switched on when the head

unit is switched on. If your head unit is not fitted with an output connector for a power antenna,

a quick-break lever switch (SPST) shall be installed between the power source (+12 V) and the

remote switch-on lead and connected to the REMOTE terminal

13 so as to provide for manual

switch-on of the amplifier.

3. Ground lead: Connect a ground lead (black) of adequate section to a clean spot on the car

chassis and to the GND terminal

12 . Make sure that the connection is sound and that there is

electric continuity between this spot and the negative terminal of the battery. Use a ground cable

as short as possible, and in case more than one amplifier are used connect all ground leads to

the same spot.

4. FUSE: In case of fuse replacement make sure to replace them with fuses of the same

amperage. The use of fuses with the wrong amperage may seriously damage the components

of the unit.

5. Speaker output terminals: Make sure to keep the right polarity and phase in connecting the

speakers. This includes the control of the right polarity, (+ and -).

NOTE: Never connect the negative wires to each other and never use a common negative lead

for all the speaker.

Take care that inadequately isolated wires do not come into contact with the the ground, metallic

parts of the car or with each other.

3-channel configuration 2-channel configuration 1-channel configuration

6. RCA-type input connectors: Connect the Pre output leads of your head unit to the RCA-type

input connectors by means of RCA extension cables (e.g. 90.05-90.10-90.25-90.50 by

MACROM).

Make sure to respect the right channel designation: left L (white) and right R (red).

1 2 3 4 5 6 7 8 9 10 11 12 ... 34 35

Pas de commentaire

Macrom 43.07 Manuel d'utilisateur Page 7